This accessory kit covers the wear parts of the passenger door linkage on Yutong buses with pneumatic outward opening door pumps. It contains the swing arm, the tension spring and the adjustable limit screw with washer and nut, so a workshop can rebuild the door linkage in one job instead of ordering each small part separately.
On an outward swing door the pump pushes the door leaf through a swing arm, and a spring plus limit screw controls the end position so the door closes flush against the body seal. When these parts wear, the symptoms are easy to recognise: the door stops short of the body, the leading edge lifts or drops, the door bounces back on closing, or the pump keeps running because the limit point is never reached.
Our kit restores the original geometry. The swing arm is stamped from zinc plated carbon steel with a hardened pin and a precise spline or bolt interface, the tension spring is wound from stainless steel wire so it keeps its rate in wet weather, and the limit screw is fully adjustable with a lock nut so the end position can be set exactly against the door seal.
| Product Type | Passenger door swing arm accessory kit |
| Part Number | DG-PD-SA |
| Kit Contents | Swing arm, tension spring, limit screw, washer, nut |
| Material | Zinc plated carbon steel, hardened pin |
| Thread Size | M8, M10 available |
| Swing Arm Length | 180mm, 220mm, 260mm available |
| Spring Type | Tension spring, stainless steel wire |
| Limit Screw | Adjustable stop screw with lock nut |
| Surface Treatment | Zinc plated with passivation |
| Salt Spray Test | 72 hours, no red rust |
| Operating Temperature | -30 C to 90 C |
| Load Capacity | 60 kg per arm |
| Vehicle Application | Yutong passenger door, outward swing door pump |
| Condition | Brand new, OEM genuine |
| Warranty | 12 months |
Arm length and thread differ between door pump models. Send us a photo of the old arm with a ruler beside it, or the centre to centre pivot distance, and we will confirm the correct size before shipment.
We supply door system and body hardware parts for fleet operators, bus body shops and distributors. Small linkage parts are consumed constantly by workshops, so we keep the common arm lengths in stock and can ship them together with door pump valves, hinges and seals in one consolidated order. Spring rate, thread fit and plating are checked on every kit before packing.
Q: My door closes but does not sit flush with the body. Will this kit solve it?
A: Usually yes. A worn swing arm pin and a stretched spring change the end position. Replacing the arm, spring and limit screw and re-adjusting the stop normally brings the door leaf back against the seal.
Q: Is the limit screw adjustable after installation?
A: Yes. Set the door against the seal, then tighten the lock nut. Fine adjustment takes only a few minutes with the door in the closed position.
Q: Do you sell the complete door pump as well?
A: Yes. We supply door pump cylinders, solenoid valves, swing arms and repair kits, so you can order a full door system repair in one shipment.
Send us the arm photo, length and quantity, and we will reply with the latest price and freight cost within one working day.
Overall Rating
Rating Snapshot
The following is the distribution of all ratingsAll Reviews