| Packaging | Carton, Wooden Box, Custom Packaging |
|---|---|
| Emergency Unlocking Type | Cockpit Pull Wire + Mechanical Key |
| Protection Level | IP67 (lock Body)/IP54 (keyhole) |
| Accessory Type | Engine Hood Mechanical Lock |
| International Certification | GB 15743-2022 |
| Precise Adaptation | Original Factory Number 1601-00632 |
|---|---|
| Fatigue Life | After 100,000 Braking Cycles |
| Thermal Fatigue Test | After 1000 Cycles Of Testing At 100℃-120℃ |
| Medium Resistance | Resistant To DOT4 Brake Fluid Immersion For 168 Hours |
| Dynamic Response | 90% Of The Standard Pressure Is Established Within 0.3 Seconds |
| Surface Protection | Electrophoretic Primer + Polyester Topcoat Double-layer Coating |
|---|---|
| Temperature Range | Operates In The Full Temperature Range From -40℃ To 85℃ |
| Bracket Design | Matching Q235 Steel Plate Stamping Bracket |
| Core Parameters | Capacity 5L, Outer Diameter Φ205mm |
| Volume Accuracy | Actual Volume Deviation ≤ ±3% |
| Vane-type Hydraulic Pump | Efficient And Stable, With Low Noise And Long Service Life |
|---|---|
| Electric Drive | Powered By The Vehicle's High-voltage Battery |
| Motor Interface | High-voltage Waterproof Connector |
| Motor Speed | 3000-6000rpm |
| Original Factory Part Number | 2121-00041 |
| Installation Location | Suitable For Side-mounted Luggage Compartment Doors, Rear-mounted Luggage Compartment Doors And Engine Compartment Doors |
|---|---|
| Humidity Adaptation | No Rust In An Environment With Humidity ≤ 95% RH |
| Impact Resistance Strength | Lock Body Compressive Strength ≥ 800MPa |
| Lock Cylinder Configuration | Using A Copper Pin Tumbler Lock Cylinder |
| Temperature Tolerance | Operating Temperature -40℃~+85℃ |
| Quality Commitment | Inspection One By One, With A Pass Rate Of 100% |
|---|---|
| Packaging | Carton, Wooden Box, Custom Packaging |
| Accessory Type | Transmission Accessories |
| Model | QC4000-02,2214-00146 |
| Applicable Scenario | Bus Transmission Shaft |
| Packaging | Carton, Wooden Box, Custom Packaging |
|---|---|
| Wear Resistance | Wear Amount ≤0.1mm/100,000 Times. |
| Sphere Material | High-strength Vulcanized Rubber |
| Accessory Type | Stabilizer Bar Components |
| Model | Stabilizer Bar Bushing |
| Carrying Capacity | Load - Bearing Capacity Of Over 5 Tons |
|---|---|
| Advantages | Height Adjustable |
| Seal Material | Fluororubber |
| Failure Testing | ≥3 Millions |
| Style | Air Bellows |
| Suspension Type | Air Spring,Air Bellow |
|---|---|
| Adapt | Mercedes-Benz Bus |
| Structural Design | Maintenance-free |
| Advantages | Height Adjustable |
| Product Material | Natural Rubber |
| Shell | ADC6 Aluminum Alloy |
|---|---|
| Built-in | Heating Module |
| Lifespan | Long-life Design |
| Wide Temperature Operating Range | -40℃~+85℃ |
| Heat | Intelligent Temperature Control |