Spring Material | 60Si2MnA Alloy Steel |
---|---|
Diaphragm Fatigue Life | 500,000 Loops Without Damage |
Diaphragm Material | Nitrile Rubber Composite Fabric |
Certification Standards | ISO 9001/GB 12676 |
Environmental Temperature Range | -40℃~+85℃ |
Types Of Oil Seals | Double-lip Oil Seal With Spring-loaded Skeleton |
---|---|
Skeleton Material | Galvanized Low-carbon Steel Skeleton |
Adapted Axle Model | Hande 425/469/500/525 Series Axles |
Certification Standards | 0.12kg±0.01kg |
Lip Edge Design | Parabolic Sealing Lip |
Dust-proof Structure | Double-layer Fluororubber Sealing Cover |
---|---|
Fatigue Life | 2 Million Times Of Loop Loading |
Vibration Test | 10~2000Hz Sine Vibration |
Connection Method | Integrally Forged Ball Pin |
Surface Treatment | Zinc-nickel Alloy Coating |
Hydrogen Embrittlement Protection | After Pickling, Carry Out Dehydrogenation Treatment At A Constant Temperature Of 200℃ For 4 Hours. |
---|---|
Lubrication System | Long-acting Lithium-based Lubricating Grease |
Installation Method | Press - Fit Quick - Release Structure |
Maintenance Interval | 1 Million Kilometers Or 60 Months |
Fatigue Life | 3 Million Times Of Loop Loading |
Compatible Vehicle Models | Buses Such As Yutong, King Long, Zhongtong, And Hengtong |
---|---|
Material Composition | High-strength Aluminum Alloy Cylinder Block |
Fatigue Life | 500,000 Cycles Of Loop Loading |
Output Characteristics | Linear Output Curve |
Surface Treatment | Hard Anodizing |
Lubrication System | Long - Acting Lithium - Based Lubricating Grease |
---|---|
Working Principle | Double Universal Joint Transmission |
Sealed Structure | Double Lip Fluororubber Oil Seal |
Connection Method | Integrally Forged Flange Plate |
Itinerary Range | Telescopic Amount ±20mm |
Vibration Test | 10 - 2000Hz Sinusoidal Vibration |
---|---|
Locking Torque | Rated Locking Torque ≥ 800N·m |
Lubrication System | Food - Grade Silicone Grease |
Material Composition | Aluminum Alloy Housing |
Sealed Structure | Double - Lip Seal Design |
Hydrogen Embrittlement Protection | After Galvanizing, Carry Out Dehydrogenation Treatment At A Constant Temperature Of 180℃ For 3 Hours. |
---|---|
Working Principle | Torsion Spring Pre - Tensioning Structure |
Material Composition | High-strength Aluminum Alloy Shell |
Tensile Force Characteristics | Rated Tension Force 600 - 1000N |
Fatigue Life | 1.2 Million Loop Loads |
Hydrogen Embrittlement Protection | After Galvanizing, Conduct Dehydrogenation Treatment At A Constant Temperature Of 200℃ For 4 Hours. |
---|---|
Lubrication System | Fully Synthetic Polyurea-based Lubricating Grease |
Applicable Range | Weichai WP10/WP12 Series Engines |
Vibration Test | 20 - 3000Hz Sinusoidal Vibration |
Maintenance Interval | 80,000 Kilometers Or 4 Years |
Install Tools | Special Hydraulic Sleeve Press |
---|---|
Corrosion Resistance | Salt Spray Test ≥ 500 Hours |
Surface Treatment | Outer Wall Phosphating |
Oil Tank Design | 3 Spiral Oil Grooves |
Execution Standards | QC/T 29097-2014 |